​• Injection system has been modified and works twice as good.
• Phase 1 and Phase 2 works with different accumulators, different pressures.
• Phase 1 precise controls highly prevent the air mixing and porosity issues for the die casted piece.
• Phase 2 easily enables reaching desired speeds and lets the die casted piece to be perfectly filled and shaped.
• Phase 3 adjustments can be easily made when necessary in accordance with the process.
• There is a significant improvement in Casting thin and sensitive parts, where %7-8 loss rate has been

  reduced to %1.
• New Phase 3 Pressure is improved in the new system. It is increases without any delay, it is provides faster cycle-     time.
• Injection piston can be stopped at any desired position. You can change the Phase 1 space distance from the monitor.
• You can change the Phase 2 speed from the monitor.

​

1. Linear motion control system-optional
2. Plc control system 10 inch monitor
3. Proportional P&Q system- optional
4. Phase 2 proportional injection speed control system – optional
5. 3 phase injection control system
6. Real time control system, continuous process control - optional
7. Low pressure die protection system-optional
8. Servo motors (provides high energy savings)-optional
9. Moving platen base support system balance the weight on the columns with heavy dies
10. Easy mounting piston rod system
11. Hydraulic injection level adjustment system
12. Hydraulic controlled die height adjustment system
13. Mold proximity sensor
14. High quality hydraulic equipment
15. Hydraulic oil temperature and level signal
16. Dosage type automatic toggle lubrication system
17. Full equipped two side automatic safety guard
18. Automatic piston, sleeve lubrication system-optional

​

​